Introduction tot the ITP/Server CFG Settings Manual

This manual describes the settings that can be configured with the file itp.cfg that can be found in the folder Config of the folder ITPWORK of your ITP/Server installation. In this file you can configure the run model and create model process. Note that these settings are rarely used; it is not very likely that you need to add settings to the itp.cfg file. More generally used settings are configured in the ITP/Server environment with the ITP/Server Administration program.

Refer to chapter Error Report Settings for more information on how to adjust the look and feel of the error document. Chapter Word Processor Settings provides an overview of the settings affecting the result document. Other available settings can be viewed in chapter Other Settings.

All documentation, with the exception of the Installation Guide and the Release Notes, can be found on the ITP Knowledge Center. The Installation Guide and Release Notes are only available for customers who have access to the support section of the corporate website.